Toyota 4Runner Quiz
Brake

Yaw Rate Sensor Malfunction (C1436)

In this manual: Brake
General — 25Audio / Visual / Telematics — 283Brake — 187Drivetrain — 204Power Source / Network — 79Steering — 76Suspension — 130Vehicle Exterior — 391Vehicle Interior — 693
2steps
~12min
1/5difficulty
Done 0 of 2
DESCRIPTION

Refer to DTC C1419 and C1435 (See page ).


DTC Code

DTC Detection Condition

Trouble Area

C1436

Either condition is met:

  1. With the vehicle stationary, the yaw rate and acceleration sensor output value is not 0°/s.
  2. An abnormal comparison value.

Yaw rate and acceleration sensor
WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (See page ).


CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the yaw rate and acceleration sensor, perform calibration (See page ).

  • Check the yaw rate and acceleration sensor signal after replacement (See page ).
PROCEDURE

  1. CHECK DTC (CAN COMMUNICATION SYSTEM)

(a) Check for DTCs (See page ).


Result

Result

Proceed to

CAN DTC is not output

A

CAN DTC is output

B

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)
A

  1. READ VALUE USING TECHSTREAM (YAW RATE SENSOR)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Select the Data List mode on the Techstream (See page ).


ABS/VSC/TRAC

Tester Display

Measurement Item/Range

Normal Condition

Diagnostic Note

Yaw Rate Sensor

Yaw rate and acceleration sensor 1 reading/ Min.: -128°/s, Max.: 127°/s

Vehicle stationary: 0°/s

Right turn: -128 to 0°/s

Left turn: 0 to 127°/s

-

(f) Check that the yaw rate and acceleration sensor output value is displayed on the Techstream.

Result

Result

Proceed to

NG

Yaw rate and acceleration sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning

A

Yaw rate and acceleration sensor output value is not 0°/s when vehicle is stationary

B

OK

C

B

REPLACE YAW RATE AND ACCELERATION SENSOR

C

USE SIMULATION METHOD TO CHECK
A

  1. CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION

(a) Turn the ignition switch off.

(b) Check that the yaw rate and acceleration sensor is installed properly (See page ).


OK:

The sensor is tightened to the specified torque.

The sensor is not installed at an angle.


OK

REPLACE YAW RATE AND ACCELERATION SENSOR

NG

INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY

Test yourself

A quick Toyota 4Runner quiz: every answer comes with an explanation and a link to the manual page.