TC and CG Terminal Circuit

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.

WIRING DIAGRAM

HINT:

When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page ).

PROCEDURE

1. INSPECT DLC3

(a) Turn the ignition switch to ON.

(b) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Switch Condition Specified Condition F13-13 (TC) - F13-4 (CG) Ignition switch ON 11 to 14 V Text in Illustration *a Front view of DLC3

NG

GO TO STEP 4

OK

1. CHECK CAN COMMUNICATION LINE

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (See page
).

OK:

CAN Bus Check indicates no malfunctions in CAN communication.

NG

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

OK

1. CHECK DTC (CAN COMMUNICATION SYSTEM)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Check for DTCs (See page ).

Result

Result	Proceed to
CAN system DTC is not output	A
CAN system DTC is output	B

B

GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

A

1. CHECK HARNESS AND CONNECTOR (ECM - DLC3)

(a) Turn the ignition switch off.

(b) Disconnect the F50 ECM connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
F50-28 (TC) - F13-13 (TC)	Always	Below 1 Ω

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

1. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
F13-4 (CG) - Body ground	Always	Below 1 Ω

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

1. CHECK ECM (DLC3 INPUT)

(a) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST: 09843-18040

(b) Check that the malfunction indicator lamp is blinking. Result Result Proceed to MIL is blinking A MIL is not blinking B Text in Illustration *a Front view of DLC3

B

REPAIR OR REPLACE WIRE HARNESS OR ECM

A

1. CHECK DTC (CAN COMMUNICATION SYSTEM)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Check for DTCs (See page ).

Result

Result	Proceed to
CAN communication system DTC is not output	A
CAN communication system DTC is output	B

A

REPLACE MASTER CYLINDER SOLENOID

B

GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)