Supplemental Restraint Systems

TC and CG terminal circuit

~2min read

DESCRIPTION

The DTC output mode is selected by connecting the TC and CG terminals of the DLC3.

DTCs are indicated by the blinking of the SRS warning light.

HINT:

  • When multiple warning lights on the combination meter blink continuously, a short to ground in the wiring or an ECU connected to the TC terminal of the DLC3 is likely.
  • A DTC output mode signal is sent to each ECU, including the airbag sensor assembly, via CAN communication. Therefore, if multiple systems fail to enter DTC output mode, there may be a malfunction in the ECM.

WIRING DIAGRAM

PROCEDURE

  1. CHECK WIRE HARNESS (TC TERMINAL OF DLC3 - TC TERMINAL OF ECM)

(a) Turn the ignition switch OFF.

*1

DLC3

*a

Front view of wire harness side connector

(to ECM)

(b) Disconnect the connector from the ECM.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F41-13 (TC) - A38-33 (TC)

Always

Below 1 Ω

NG

REPAIR OR REPLACE WIRE HARNESS

OK
  1. CHECK WIRE HARNESS (CG TERMINAL OF DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F41-4 (CG) - Body Ground

Always

Below 1 Ω

*1

DLC3

NG

REPAIR OR REPLACE WIRE HARNESS

OK
  1. CHECK WIRE HARNESS (TC TERMINAL OF DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F41-13 (TC) - Body Ground

Always

1 MΩ or higher

*1

DLC3

OK

REPLACE AIRBAG SENSOR ASSEMBLY

NG

REPAIR OR REPLACE WIRE HARNESS OR REPLACE EACH ECU