How to Use Troubleshooting
PRECAUTION / NOTICE / HINT
HINT:
- Perform the following procedure to troubleshoot the airbag system.
- *: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS
(a) Confirm the malfunction symptoms.
Click here
![]()
|
CHECK CAN COMMUNICATION SYSTEM*
(a) Using the Techstream, check whether the CAN communication system operates normally.
OK:
The CAN communication system operates normally.
HINT:
- Refer to the CAN Bus Check section in the CAN communication system.
Click here
.gif)
- The airbag sensor assembly is connected to the CAN communication system. Therefore, before starting troubleshooting, check that there is no malfunction in the CAN communication system.
| NG | GO TO CAN COMMUNICATION SYSTEM |
|
SRS WARNING LIGHT CHECK
(a) Go to Diagnostic System.
Click here![]()
|
CHECK DTCs*
(a) Go to DTC Check / Clear.
Click here![]()
OK:
No DTCs are output.
| NG | GO TO STEP 12 |
|
SIMULATE SYMPTOMS
(a) Go to the How to Proceed with Troubleshooting section.
Click here
![]()
|
SYMPTOM TROUBLESHOOTING TABLE
(a) Go to the Problem Symptoms Table.
Click here
![]()
|
CIRCUIT INSPECTION*
|
PROBLEM SYMPTOMS TABLE
|
REPAIR OR REPLACEMENT
|
CONFIRMATION TEST
| NEXT | END |
DTC CHART
(a) Go to the Diagnostic Trouble Code Chart.
Click here
![]()
|
CIRCUIT INSPECTION*
|
PROBLEM SYMPTOMS TABLE
|
REPAIR OR REPLACEMENT
|
CONFIRMATION TEST
| NEXT | END |