Supplemental Restraint Systems

Front Left Airbag Sensor Malfunction (B1615/14)

~3min read

DESCRIPTION

The front left airbag sensor circuit consists of the airbag sensor assembly and the front left airbag sensor.

The front left airbag sensor detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine whether the airbags and pretensioners should be deployed.

DTC B1615/14 is stored when a malfunction is detected in the front left airbag sensor.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Test Mode / Check Mode

B1615/14

Front airbag sensor LH malfunction

One of the following conditions is met

  • Front airbag sensor LH malfunction
  • Airbag Sensor Assembly Malfunction
  • Front airbag sensor LH
  • Airbag sensor assembly

Not applicable to test mode / check mode

DTC detection conditions:

Vehicle Operating Conditions

Sequence 1

Sequence 2

Diagnostic Condition

Ignition Switch in ON position

○

○

Malfunction Status

Front airbag sensor LH malfunction

○

-

Airbag Sensor Assembly Malfunction

-

○

Detection Duration

-

-

Number of Trips

1 trip(s)

1 trip(s)

HINT:

The DTC is output when the conditions for any one of the sequences in the table above are met.

WIRING DIAGRAM

Click here

PRECAUTION / NOTICE / HINT

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

PROCEDURE

  1. INSPECT FRONT LEFT AIRBAG SENSOR

(a) Turn the ignition switch OFF.

*A

with occupant classification system

*B

with occupant classification system

*1

Front airbag sensor RH

*2

Airbag sensor assembly

(b) Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Swap the front left and front right airbag sensors, then connect their connectors.

(d) Connect the cable to the negative (-) battery terminal.

(e) Clear the DTCs stored in memory.

Click here

Body Electrical > SRS Airbag > Clear DTCs

(f) Turn the ignition switch to the OFF position.

(g) Turn the ignition switch to ON and wait for at least 60 seconds.

(h) Check the DTCs.

Click here

Body Electrical > SRS Airbag > Trouble Codes

HINT:

Codes other than DTCs B1610/13 and B1615/14 may be output at this point, but they are not related to this check.

Result:

Result

Proceed to

DTCs B1610/13 and B1615/14 are not output.

A

DTC B1615/14 is output.

B

DTC B1610/13 is output.

C

(i) Turn the ignition switch to OFF.

(j) Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(k) Return the front left and right airbag sensors to their original positions and connect the connectors.

A

USE SIMULATION METHOD TO CHECK

B

REPLACE AIRBAG SENSOR ASSEMBLY

C

REPLACE FRONT LEFT AIRBAG SENSOR