Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures required (adjustment, calibration, initialization or registration) that must be performed after the parts have been removed and installed or replaced during removal/installation of the dimmer switch assembly are listed below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Necessary Procedures | Effects / Inoperative Function When Necessary Procedure Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
CAUTION:
Some service operations affect the SRS airbag system. Before starting any service operation, carefully read the precautions for the SRS airbag system.
Click here
![]()
PROCEDURE
1. REMOVE SPIRAL CABLE SUBASSEMBLY WITH SENSOR
Click here
![]()
2. REMOVE FRONT WIPER SWITCH ASSEMBLY
Click here![]()
3. REMOVE DIMMER SWITCH ASSEMBLY
(a) Disconnect the connector.
![]() |
Remove in this direction |
(b) Release the claws to remove the dimmer switch assembly as shown in the illustration.
.gif)
.png)