Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during battery removal/installation are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Required Procedure | Effect/Inoperative function when procedure not performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
PROCEDURE
1. PRECAUTIONS
NOTICE:
After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.
Click here
![]()
2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL
(a) Loosen the nut and disconnect the cable from the battery negative (-) terminal. NOTICE: When the cable has been disconnected, some systems must be reset after the cable is reconnected. Click here |
![]() |
3. REMOVE BATTERY
(a) Release the 2 claws to remove the fuse block cover. |
![]() |
(b) Loosen the nut. |
![]() |
(c) Release the clamp and disconnect the cable from the battery positive (+) terminal. |
![]() |
(d) Remove the battery insulator from the battery. |
![]() |
(e) Remove the bolt and battery clamp No. 2. |
![]() |
(f) Remove the battery from the vehicle. |
![]() |
.gif)






