Maintenance

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during removal/installation of the ignition coil assembly or ignition coil are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Required Procedure

Effect/Inoperative function when procedure not performed

Link

Ignition Coil Assembly Replacement

Verification after Repair

  • Poor idling, etc.
  • Engine start function, etc.
  • with fuel vapor absorber pump module:
  • without fuel vapor absorber pump module:

Spark Plug Replacement

PROCEDURE

1. REMOVE NO. 2 CYLINDER HEAD COVER

Click here

2. REMOVE IGNITION COIL ASSEMBLY

Click here

3. REMOVE SPARK PLUG

(a) Remove the 4 spark plugs from the cylinder head sub-assembly.

NOTICE:

If a spark plug has been dropped or subjected to an impact, replace it.

HINT:

Arrange the removed parts in the correct order.