Maintenance
Installation
In this manual: Maintenance
~1min read
INSTALLATION
PROCEDURE
1. INSTALL SPARK PLUG
HINT:
Perform the "Verification after Repair" procedure after replacing a spark plug.
- with fuel vapor absorber pump module:
Click here
.gif)
- without fuel vapor absorber pump module:
Click here
.gif)
(a) Install the 4 spark plugs to the cylinder head sub-assembly.
Torque:
20 N·m {204 kgf·cm, 15 ft·lbf}
NOTICE:
If a spark plug has been dropped or subjected to an impact, replace it.
HINT:
Install the same parts in their original positions.
2. INSTALL IGNITION COIL ASSEMBLY
Click here![]()
3. INSTALL NO. 2 CYLINDER HEAD COVER
Click here![]()
4. PERFORM INITIALIZATION
(a) Perform the "Verification after Repair" after replacing a spark plug or ignition coil assembly.
- with fuel vapor absorber pump module:
Click here
.gif)
- without fuel vapor absorber pump module:
Click here
.gif)
Was this page helpful?