Maintenance

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

HINT:

  • The following procedure applies to the left side.
  • Repeat the same procedure for the right side and the left side.

PROCEDURE

1. PRECAUTIONS

Click here

2. REMOVE REAR WHEEL

Click here

3. PERFORM REAR BRAKE PAD REPLACEMENT MODE

Click here

4. DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto a painted surface, wipe it off immediately.

5. REMOVE REAR DISC BRAKE PAD

CAUTION:

  • After lifting up the rear disc brake caliper assembly, place it in position before working on it.
  • The rear disc brake caliper assembly may fall and cause serious injury to your hands or fingers.

(a) Disconnect the No. 2 parking brake cable assembly connector from the parking brake actuator assembly.

(b) Hold the rear disc brake caliper slide pin and remove the bolt.

*a

Hold

*b

Turn

(c) Pull the rear disc brake caliper assembly upward.

(d) Remove the 2 rear disc brake pads from the rear disc brake caliper bracket.

6. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

(a) Remove the No. 1 rear disc brake anti-squeal shim and the No. 2 rear disc brake anti-squeal shim from each rear disc brake pad.

(b) Using a screwdriver, remove the wear indicator plate from each rear disc brake pad.