Maintenance

Installation

~3min read
02040608010034.325N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

NOTICE:

After replacing the rear disc brake pads, the brake pedal may feel soft due to the clearance between the rear disc brake pads and the rear disc. Depress the brake pedal several times until the pedal feels firm.

HINT:

  • The following procedure applies to the left side.
  • Repeat the same procedure for the right side and the left side.

PROCEDURE

1. INSTALL REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

NOTICE:

When replacing worn rear disc brake pads, the rear disc brake anti-squeal shim kit must be replaced together with the rear disc brake pads.

(a) Inspect the rear disc brake pad.

HINT:

If the rear disc brake pad has an identification mark, make sure to check the installation location.

*a

Inner side (brown)

*b

Outer side (green)

(b) Install 2 rear disc brake pad wear indicator plates on each rear disc brake pad.

NOTICE:

Install the rear disc brake pad wear indicator plates in the correct position and direction.

*1

No. 1 Rear Disc Brake Anti-Squeal Shim

*2

No. 2 Rear Disc Brake Anti-Squeal Shim

*3

Rear Disc Brake Pad Wear Indicator Plate

*a

Claw

(c) Install the No. 1 rear disc brake anti-squeal shim and the No. 2 rear disc brake anti-squeal shim on each rear disc brake pad.

NOTICE:

  • Install the No. 1 rear disc brake anti-squeal shim and the No. 2 rear disc brake anti-squeal shim in the correct position and direction, as shown in the illustration.
  • Install the No. 1 disc brake anti-squeal shim and the No. 2 disc brake anti-squeal shim using the tabs at the locations shown in the illustration on the outside of the vehicle.
  • Install so that the tabs face the outside of the vehicle.

2. INSTALL REAR DISC BRAKE PAD KIT

CAUTION:

  • After lifting up the rear disc brake caliper assembly, place it in position before working on it.
  • The rear disc brake caliper assembly may fall and cause serious injury to your hands or fingers.

(a) Push in the rear disc brake piston.

NOTICE:

Do not force the rear disc brake piston into the rear disc brake cylinder assembly.

(b) Install the 2 rear disc brake pads on the rear disc brake caliper bracket.

NOTICE:

Make sure that disc brake grease has been applied to the friction material surface of the disc brake pad.

(c) Hold the rear disc brake caliper guide pin and install the rear disc brake caliper assembly on the rear disc brake caliper bracket with a new bolt.

Torque:

34 N·m {350 kgf·cm, 25 ft·lbf}

*a

Hold

*b

Turn

(d) Depress the brake pedal several times.

3. ADD BRAKE FLUID

Click here

4. INSTALL REAR WHEEL

Click here

5. RESTORE NORMAL OPERATION

Click here