Toyota Camry Quiz
Introduction

Drive belt (1MZ−FE/3MZ−FE)

In this manual: Introduction
Introduction — 61Audio & visual system — 16Automatic transmission / trans — 19Transmission revolution (ATM) — 1Shift lock system (ATM) — 1Brake — 20Clutch — 10Communication system — 4Cooling — 15Cruise control — 3Drive shaft / propeller shaft — 9Emission control — 8Engine control system — 12Engine hood/door — 7Exhaust — 3Exterior/interior trim — 14Front suspension — 9Fuel — 12Heater & air conditioner — 16Ignition — 8Instrument panel/meter — 7Intake — 7Lighting — 11Lubrication — 16Manual transmission/transaxle — 13Parking brake — 10Power steering — 7Rear suspension — 10Seat — 12Service specifications — 26Sliding roof/convertible — 4Starting & charging — 11Starting system (2AZ−FE)(From July, 2003) — 1Starting system (1MZ−FE/3MZ−FE) — 1Steering column — 6Theft deterrent & door lock — 9Tire & wheel — 4Windshield/windowglass/mirror — 5Back window glass — 1Power window control system — 1Power mirror control system — 1Inner rear view mirror assy — 1Windshield glass — 1Wiring — 1
13steps
~78min
3/5difficulty
0204060801004332N·mlb·ft
Tightening torque found on this page
Done 0 of 13
REPLACEMENT
  1. REMOVE FRONT WHEEL RH
  2. REMOVE FRONT FENDER APRON SEAL RH
  3. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT No.1

  4. Loosen bolts A and B.

  5. Loosen adjusting bolt C and remove the belt.

Remove V (cooler compressor to crankshaft pulley) belt No.1 Remove V (cooler compressor to crankshaft pulley) belt No.1 4. REMOVE VANE PUMP V BELT

a. Loosen bolts A and B, and remove the belt.

Remove vane pump V belt
Remove vane pump V belt 5. INSTALL VANE PUMP V BELT

  1. Install the belt on each pulley.

  2. Using a bar, adjust the belt tension and tighten bolt B.

    Torque: 43 N·m

  3. Tighten bolt A.

    Torque: 43 N·m
Install vane pump V belt
Install vane pump V belt 6. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT No.1

  1. Install the belt on each pulley.

  2. Tighten adjusting bolt C, and adjust the belt tension.

  3. First tighten bolt A, then B.

    Torque:
    58 N·m for bolt A 18 N·m for bolt B
Install V (cooler compressor to crankshaft pulley) belt No.1
Install V (cooler compressor to crankshaft pulley) belt No.1
  1. INSPECT DRIVE BELT TENSION
  2. INSTALL FRONT WHEEL RH

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.