Engine rear oil seal (1MZ−FE/3MZ−FE)

REPLACEMENT

1. 1
   REMOVE AUTOMATIC TRANSAXLE ASSY
2. 2
   REMOVE DRIVE PLATE & RING GEAR SUB−ASSY

a. Using SST, hold the crankshaft.

SST 09213−54015 (91651−60855), 09330−00021

b. Remove the 8 bolts, the rear spacer, the drive plate and the front spacer.

3. REMOVE ENGINE REAR OIL SEAL

1. 1

   Using a knife, cut off the oil seal lip.

2. 2

   Using a screwdriver with its tip wrapped in tape, pry out the oil seal.

NOTICE: After the removal, check if the crankshaft is not damaged.

If it is damaged, smooth the surface with 400−grit sandpaper.
Remove engine rear oil seal 4. INSTALL ENGINE REAR OIL SEAL

a. Apply MP grease to a new oil seal lip.

NOTICE: Keep the lip off foreign materials.

b. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST 09223−15030, 09950−70010 (09951−07100)

NOTICE:

• Be careful not to tap the oil seal at an angle.
• Wipe off extra grease from the crankshaft.

Install engine rear oil seal 5. INSTALL DRIVE PLATE & RING GEAR SUB−ASSY

1. 1

   Using SST, hold the crankshaft.

   SST 09213−54015 (91651−60855), 09330−00021

2. 2

   Clean the bolts and bolt holes.

3. 3

   Apply adhesive to 2 or 3 threads of the bolts.

   Adhesive:
   Part No. 08833−00070, THREE BOND 1324 or equivalent
4. 4

   Install the front spacer, the drive plate and the rear spacer on the crankshaft.

   

e. Uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

Torque: 83 N·m NOTICE: Do not start the engine for at least an hour after installing.

6. INSTALL AUTOMATIC TRANSAXLE ASSY