Toyota Sienna Quiz
Engine

Fuel Pump Primary Circuit

In this manual: Engine
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~2min read
Fuel Pump Primary Circuit

DESCRIPTION

  • This DTC is designed to detect a malfunction in the fuel pump (FUEL PUMP) relay circuit. When the system is normal, the battery voltage is applied to FPR terminal of the ECM while the FUEL PUMP relay is turned OFF. If the battery voltage is not applied to the FPR terminal while the FUEL PUMP relay is OFF, the ECM interprets this as a malfunction. The ECM then illuminates the MIL and sets a DTC.
  • The FUEL PUMP relay switches the fuel pump speed according to the engine conditions. The fuel pump operates when the ECM receives the starter-operating signal (STA) and crankshaft-rotating signal (NE). The FUEL PUMP relay is turned ON while the engine is idling or operating at low load.
This causes current to flow through the fuel pump resistor to the fuel pump. The fuel pump then operates at low speed. The FUEL PUMP relay is turned OFF while the engine is cranking or operating at high load. The fuel pump then operates at normal speed.
Fuel Pump Primary Circuit

WIRING DIAGRAM

WIRING DIAGRAM

This troubleshooting procedure is based on the premise that the engine is started. If the engine is not started, proceed to the problem symptoms table (See page ES-27).

INSPECTION PROCEDURE

1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER

(a) Connect the intelligent tester to the DLC3.

(b) Turn the ignition switch to the ON position and turn the intelligent tester ON.

(c) Enter the following menus: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST / FUEL PUMP SP CTL.

(d) Check the operation of the relay while operating it using the intelligent tester.

OK: Operating noise can be heard from the relay.

2 INSPECT RELAY (FUEL PUMP RELAY)

INSPECT RELAY (FUEL PUMP RELAY)

(a) Remove the FUEL PUMP relay from the engine room junction block.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance

(c) Reinstall the FUEL PUMP relay.

3 CHECK HARNESS AND CONNECTOR (FUEL PUMP RELAY - ECM)

CHECK HARNESS AND CONNECTOR (FUEL PUMP RELAY - ECM)

(a) Remove the FUEL PUMP relay from the engine room junction block.

(b) Disconnect the E11 ECM connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance

(d) Reconnect the ECM connector.

(e) Reinstall the FUEL PUMP relay

REPLACE ECM (See page ES-498)

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.