|
HINT:
- The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
- *: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
| NEXT |
 |
|
CUSTOMER PROBLEM ANALYSIS
(a) Refer to the How to Troubleshoot ECU Controlled Systems in Introduction section.
Click here 
| NEXT |
 |
|
INSPECT BATTERY VOLTAGE
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
 |
|
CONNECT TECHSTREAM TO DLC3*
| NEXT |
 |
|
CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
(a) Refer to DTC Check/Clear.
Click here 
| NEXT |
 |
|
VISUAL INSPECTION
| NEXT |
 |
|
SELECT CHECK MODE DIAGNOSIS*
(a) Refer to the Check Mode Procedure.
Click here 
| NEXT |
 |
|
PROBLEM SYMPTOM CONFIRMATION
(a) Refer to the Road Test.
Click here 
Result | Proceed to |
Symptom does not occur |
A |
Symptom occurs |
B |
| B |
 |
GO TO STEP 10 |
| A |
 |
|
SYMPTOM SIMULATION
(a) Refer to the Electronic Circuit Inspection Procedure.
Click here 
| NEXT |
 |
|
DTC CHECK*
(a) Refer to DTC Check/Clear.
Click here 
Result | Proceed to |
DTC is not output |
A |
DTC is output |
B |
| B |
 |
GO TO STEP 18 |
| A |
 |
|
BASIC INSPECTION
(a) Refer to Park/Neutral Position Switch.
Click here 
(b) Refer to Shift Lever Assembly.
- For Column Shift Type, refer to the following procedures.
Click here 
- For Floor Shift Type, refer to the following procedures.
Click here 
| NG |
 |
GO TO STEP 21 |
| OK |
 |
|
MECHANICAL SYSTEM TESTS
(a) Refer to the Mechanical System Tests.
Click here 
| NG |
 |
GO TO STEP 17 |
| OK |
 |
|
HYDRAULIC TEST
(a) Refer to the Hydraulic Test.
Click here 
| NG |
 |
GO TO STEP 17 |
| OK |
 |
|
MANUAL SHIFTING TEST
(a) Refer to the Manual Shifting Test.
Click here 
| NG |
 |
GO TO STEP 16 |
| OK |
 |
|
PROBLEM SYMPTOMS TABLE CHAPTER 1
(a) Refer to the Problem Symptoms Table.
Click here 
| NG |
 |
GO TO STEP 19 |
| OK |
 |
|
PROBLEM SYMPTOMS TABLE CHAPTER 2
(a) Refer to the Problem Symptoms Table.
Click here 
| NEXT |
 |
|
PART INSPECTION
| NG |
 |
GO TO STEP 21 |
| OK |
 |
|
DTC CHART
(a) Refer to the Diagnostic Trouble Code Chart.
Click here 
| NEXT |
 |
|
CIRCUIT INSPECTION
| NEXT |
 |
|
IDENTIFICATION OF PROBLEM
| NEXT |
 |
|
REPAIR OR REPLACE
| NEXT |
 |
|
CONFIRMATION TEST
| NEXT |
 |
END |
|