Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2) (P0778)
In this manual: Engine, Hybrid System
~3min read
DESCRIPTION
Shifting from 1st to 6th is performed in combination with the ON and OFF operation of the shift solenoid valves SL1, SL2, S1, S2, S3, S4 and SR, which are controlled by the ECM. If an open or short circuit occurs in the shift solenoid valves, the ECM controls the remaining normal shift solenoid valves to allow the vehicle to be operated safely (See page ).
DTC Code
DTC Detection Condition
Trouble Area
P0778
The ECM checks for an open or short in the shift solenoid valve SL2 circuit while driving and shifting gears (1-trip detection logic).
Output signal duty equals 100%.
HINT:
SL2 output signal duty is less than 100% under normal conditions.
Open or short in shift solenoid valve SL2 circuit
Shift solenoid valve SL2
ECM
MONITOR DESCRIPTION
This DTC indicates an open or short in the shift solenoid valve SL2 circuit. The ECM commands gear shifts by turning the shift solenoid valves ON/OFF. When there is an open or short circuit in any shift solenoid valve circuit, the ECM detects the problem, illuminates the MIL and stores the DTC. Also, the ECM performs the fail-safe function and turns the other normal shift solenoid valves ON/OFF. In case of an open or short circuit, the ECM stops sending current to the open or short-circuited solenoid.
While driving and shifting gears, if the ECM detects an open or short in the shift solenoid valve SL2 circuit, the ECM determines there is a malfunction (See page ).
MONITOR STRATEGY
Related DTCs
P0778: Shift solenoid valve SL2/Range check
Required sensors/Components
Shift solenoid valve SL2
Frequency of operation
Continuous
Duration
1 second
MIL operation
Immediately
Sequence of operation
None
TYPICAL ENABLING CONDITIONS
The monitor will run whenever the following DTCs are not present
None
Solenoid current cut status
Not cut
Battery voltage
11 V or more
Ignition switch
ON
Starter
OFF
TYPICAL MALFUNCTION THRESHOLDS
Solenoid status from solenoid driver MIC
Fail
COMPONENT OPERATING RANGE
Output signal duty
Less than 100%
WIRING DIAGRAM
NOTICE:
Perform the universal trip to clear permanent DTCs (See page ).
HINT:
The shift solenoid valve SL2 is turned ON/OFF normally when the shift lever is in D: