Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) (P2716)
In this manual: Engine, Hybrid System
~2min read
DESCRIPTION
Refer to DTC P0894 (See page ).
DTC Code
DTC Detection Condition
Trouble Area
P2716
Open or short is detected in the shift solenoid valve SLT circuit for 1 second or more while driving (1-trip detection logic).
Open or short in shift solenoid valve SLT circuit
Shift solenoid valve SLT
ECM
MONITOR DESCRIPTION
When an open or short in the shift solenoid valve SLT circuit is detected, the ECM interprets this as a fault. The ECM will turn on the MIL and store the DTC.
MONITOR STRATEGY
Related DTCs
P2716: Shift solenoid valve SLT/Range check
Required sensors/Components
Shift solenoid valve SLT
Frequency of operation
Continuous
Duration
1 second
MIL operation
Immediately
Sequence of operation
None
TYPICAL ENABLING CONDITIONS
The monitor will run whenever the following DTCs are not present
None
Solenoid current cut status
Not cut
Battery voltage
11 V or more
Ignition switch
ON
Starter
OFF
TYPICAL MALFUNCTION THRESHOLDS
Solenoid voltage monitor signal from solenoid driver MIC
No signal
COMPONENT OPERATING RANGE
Output signal duty
Less than 100%
WIRING DIAGRAM
NOTICE:
Perform the universal trip to clear permanent DTCs (See page ).