Прикрепление и удаление буксировки

Используйте буксировку при буксировке. Screw the towing eyelet securely into place in the threaded outlet behind the cover on the righthand side of the front and rear bumpers.

Прикрепление буксирного

Take out the towing eyelet, which is stored in a foam block under the floor in the cargo compartment.

Front: Remove the cover – use the vehicle key or a small screwdriver in the notch to carefully pry off the cover.

• Крышка поворачивается вдоль своей центральной линии и может быть удалена.

Rear: Remove the cover by pressing on the mark with a finger while folding out the opposite side/corner.

• Крышка поворачивается вдоль своей центральной линии и может быть удалена.

4. Screw the towing eyelet in as far as possible.

   

   Fasten the eyelet securing by, for example, inserting a lug wrench* through it and using this as a lever.

Рассмотреть перед использованием буксирного элева

• In certain conditions, the towing eyelet may be used to pull the vehicle onto a flatbed tow truck. The vehicle's position and ground clearance determines if this is possible.
• If the incline of the tow truck is too steep or if the ground clearance under the vehicle is insufficient, attempting to pull it up using the towing eyelet may result in damage.
• If necessary, lift the vehicle using the tow truck's lifting device instead of using the towing eyelet.

Удаление буксировки

• Открутите буксирующий эйлет после использования и верните его в блок пенопласта. Replace the cover on the bumper.

* Опция/аксессуар.