Программирование Homelink®

(Опция/аксессуар.) (Только определенные рынки.)

Follow these instructions to program HomeLink®, reset all programming, or program individual buttons.

1. 1
   Point the remote control at the HomeLink® button to be programmed and hold it about 2-8 cm (1-3 inches) from the button. Do not obstruct the HomeLink® indicator light.

   Note: Some remote controls are more effective at programming HomeLink® from a distance of about 15-20 cm (6-12 inches). Keep this in mind if you experience any programming difficulties.

2. 2
   Press and hold both the remote control button and the HomeLink® button to be programmed.
3. 3
   Do not release the buttons until the indicator light has stopped flashing slowly (about once a second) and either flashes quickly (about 10 times a second) or glows steadily.

   • Если индикатор светится постоянно: Indication that programming is complete. Press the programmed button twice to activate.

     If the indicator light flashes quickly: The device being programmed with HomeLink® may have a security function that requires an extra step. Try pressing the programmed button twice to see whether the programming works. Otherwise, continue with the following steps.

   

4. 4
   Locate the "training" button¹ on the receiver for the e.g. garage door opener. It is usually located near the antenna bracket on the receiver.
5. 5
   Нажмите и отпустите кнопку «Обучение» один раз. Programming must be completed within 30 seconds after pressing the button.
6. 6
   Press and release the HomeLink® button to be programmed. Repeat the press/ hold/release sequence a second time. For some receivers, the sequence may need to be repeated a third time.

   • Программирование теперь завершено, а гаражная дверь, ворота и т. Д. should now be activated when the programmed button is pressed.

If you experience any difficulties programming, please contact HomeLink® at: homelink.com, or call 1–800–355–3515.

Программирование отдельных кнопок

Чтобы запрограммировать индивидуальную кнопку Homelink®:

1. 1
   Нажмите и удерживайте нужную кнопку примерно на 20 секунд.
2. 2
   When the indicator light on HomeLink® starts flashing slowly, it is possible to program as usual.

   Note: If the button you are reprogramming does not program with a new device, it will return to the previously saved programming.

Сбросить кнопки Homelink®

Можно сбросить все кнопки Homelink® одновременно. It is not possible to reset individual buttons. Отдельные кнопки могут быть перепрограммированы только.

• Press and hold the outer buttons (1 and 3) on HomeLink® for about 10 seconds.
  • When the indicator light goes from a steady glow to flashing, the buttons have been reset and are ready for reprogramming.

¹ The name and color of the button varies depending on the manufacturer.