Caution Do not place objects or install equipment on or near the front side airbag cover or the rear seatback, or in locations that may contact a deploying airbag. Failure to follow these instructions may increase the risk of injury in a crash.
Do not secure antenna cables to the vehicle wiring, fuel lines, and brake lines.
Keep the antenna and power cables at least 4 in (10 cm) away from any electronic modules and airbags.
NOTE We test and certify your vehicle to comply with electromagnetic compatibility regulations. You are responsible for ensuring that any equipment installed on your vehicle by an authorized dealer complies with applicable local regulations and other requirements. Installation of some aftermarket electronic devices may degrade the performance of vehicle functions that use radio frequency signals, such as the broadcast radio receiver, tire pressure monitoring system, push-button start, Bluetooth connection, or satellite navigation.
Any radio frequency transmitter equipment in your vehicle (for example, cellular telephones and amateur radio transmitters) must comply with the parameters in the following illustrations and table. We do not provide any other special provisions or conditions for installation or use.
Car
Van
Truck
Appendices
NOTE After installing a radio frequency transmitter, check for interference from all electrical equipment in your vehicle, in both standby and transmit modes.
Check all electrical equipment:
With the ignition on.
With the engine running.
During road tests at different speeds.
Make sure the electromagnetic fields generated in the passenger compartment of your vehicle by the installed transmitter do not exceed the applicable human exposure requirements.