Semi-Automatic Operation

While the system is operating in automatic mode, you can manually adjust various system functions. The system will continue to control all other functions automatically. The AUTO indicator will go off in the display.

Air Conditioner Switch

To turn the air conditioner on and off, press the A/C button.

The corresponding A/C ON or A/C OFF indicator appears in the display.

After the air conditioner has been turned off manually, the climate control system will not be able to maintain the set temperature of the air supplied to the cabin if it is lower than the ambient air temperature.

Recirculation Button

If the recirculation indicator is on, air circulates inside the vehicle in a closed loop. If the recirculation indicator is off, outside air enters the vehicle.

Outside air enters the climate control system through the air intake grilles located at the base of the windshield. Periodically clean the air intake grille openings of leaves and debris.

In most cases, it is preferable to have outside air enter the passenger compartment.

Prolonged use of recirculation mode, especially with the air conditioner off, causes moisture to condense on the windows.

Therefore, it is recommended to use recirculation mode to prevent smoke or dust from entering the passenger compartment. As soon as this is no longer necessary, turn off the recirculation mode.

Blower Speed Adjustment. Select the blower speed by pressing the corresponding side of the blower speed control button.The blower speed value is shown in the display as a bar indicator.

MODE Button (Cabin Air Distribution)

The MODE button is used to select the airflow distribution mode in the cabin. Regardless of the selected mode, some air will enter the cabin through the side vents on the control panel.

Each time the MODE button is pressed, the selected mode changes.

Air enters the cabin through the floor vents, side vents and windshield defrost slots.

Air enters the cabin through the floor vents and side vents.

Air enters the cabin through the control panel vents and floor vents.

Air enters the cabin through the center and side vents on the control panel.

Windshield Defrost Switch.

When this button is pressed, the main airflow is directed to the windshield to quickly clear frost and moisture. The previously selected airflow mode is canceled.

When the switch is pressed, the outside air mode is automatically activated and the air conditioner is turned on. To speed up windshield clearing, it is recommended to manually set a high blower speed. It is also recommended to temporarily close the side vents on the control panel.

When the switch is pressed again, the system returns to its previous operating mode.

To clear condensation and frost from the inside of the windows, proceed as follows:

1. Select the . mode to clear condensation and frost.

4. To increase the airflow to the windshield, close the side vents on the control panel. To quickly clear condensation from the windows, select the maximum blower speed.

For safety reasons, do not start driving until you have a clear view through all vehicle windows.

When the indicator built into the button is on, you cannot set a passenger zone temperature different from the driver zone temperature.

Rear Window Defogger switch

This switch is used to turn the rear window defroster on and off.

The outside rearview mirror heaters switch on and off together with the rear window heater.