Battery Replacement

(For EU countries)

When replacing the battery, always follow the instructions in "General Safety Precautions for Vehicle Maintenance" on page 426.

To prevent accidents, follow the warnings given in "Battery Condition Inspection".

1. Make sure the ignition key is in the LOCK (0) position.

3. Loosen the negative terminal clamp bolt, then disconnect the negative cable (-).

Always disconnect the negative (–) cable first, and connect it last.

4. Open the protective cover of the positive battery terminal. Loosen the positive terminal clamp bolt, then disconnect the positive cable.

For vehicles with a diesel engine: Remove the clip from the holder located on the side of the battery case, and remove the cable.

5. Using a wrench, loosen the nuts securing both sides of the battery hold-down clamp.

6. Pull the lower end of each hold-down rod out of the holes in the battery tray, and remove the rods together with the clamp.

7. If necessary, remove the battery cover.

8. Carefully remove the battery.

Installation of the new battery is performed in the reverse order of removal.

Referring to the illustration on the previous page, make sure the battery hold-down clamp is installed correctly.

This symbol on the battery means that it must not be disposed of with ordinary household waste.

Improper battery disposal may harm the environment and human health. Battery disposal must be carried out in accordance with local regulations and standards.