Hyundai Accent Quiz
SOHC Engines

Installation of Front Oil Seal

In this manual: SOHC Engines
Owner's Manual — 155SOHC Engines — 75DOHC Engines — 49Lubrication System — 14Cooling System — 23Emission Control — 3PCV Valve — 5Fuel system — 44Ignition System — 12Clutch — 17Manual transmission — 14Automatic transmission — 24Axle Shafts and Drive Shafts — 17Suspension — 31Steering — 45Brake System — 39Body — 23Air Conditioning System — 32Electrical Equipment — 54Appendix — 9Wiring Diagrams — 3
~1min read

PROCEDURE

1. Inspect the front oil seal for wear or damage to the sealing lip and replace if necessary.
2. Inspect the condition of the garter spring that holds the sealing lip of the oil seal.

3. Смажьте наружную поверхность нового уплотнительного кольца моторным маслом.

3. Lubricate the outer surface of the new oil seal with engine oil. Using special tool 09231–22100 or a sleeve of suitable diameter, install the oil seal onto the crankshaft until it contacts the front cover.

4. Специальным инструментом 09231–22000 установите уплотнительное кольцо до упора

4. Using special tool 09231–22000, install the oil seal fully into the front cover bore.
5. Install the crankshaft pulley, timing belt, and crankshaft pulley.
6. Install the oil filter.
7. Clean the mating surfaces of the oil pan and cylinder block of old gasket residue.

8. Нанесите непрерывный слой герметика диаметром 4 мм на сопрягаемую поверхность

8. Apply a continuous bead of sealant, 4 mm in diameter, to the oil pan mating surface. Apply sealant on the inside of the bolt holes. Install the oil pan within 15 minutes after applying the sealant.
9. Install the oil pan onto the cylinder block and secure with bolts.
Tightening torque: 6–8 N·m

Test yourself

A quick Hyundai Accent quiz: every answer comes with an explanation and a link to the manual page.