Hyundai Elantra CN7 Quiz

Crankshaft Position Sensor (CKP SENSOR)

In this manual: Crankshaft Position Sensor (CKP SENSOR)
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read
01020304050118N·mlb·ft
Tightening torque found on this page

ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА (СКР SENSOR)
CRANKSHAFT POSITION SENSOR (CKP SENSOR)

The crankshaft position sensor (magnetic induction type) consists of a magnet and a coil located near the engine flywheel. Based on the signals (voltage pulses) from the crankshaft position sensor, the engine control module determines the crankshaft rotational speed (RPM) and the position of the crankshaft throws.


CIRCUIT DIAGRAM - CRANKSHAFT POSITION SENSOR (CKP SENSOR)

WIRING INSPECTION (FOR 1.6L I4 ENGINE)

ПРОВЕРКА ЭЛЕКТРОПРОВОДКИ (ДЛЯ ДВИГАТЕЛЕЙ [1.8/2.0L I4])

WIRING INSPECTION (FOR 1.8/2.0L I4 ENGINES)

ПРОВЕРКА ДАТЧИКА (ДЛЯ ДВИГАТЕЛЯ [1.6L I4])

SENSOR INSPECTION (FOR 1.6L I4 ENGINE)

1. Disconnect the crankshaft position sensor connector.

2. Measure the resistance between sensor terminals 1 and 2.

Specified value: 0.486 - 0.594 kΩ at 20 °C

3. Если измеренное сопротивление не соответствует номинальному значению, то замените

3. If the measured resistance does not match the specified value, replace the sensor.

Specification - Clearance between sensor rotor tooth and sensor tip: 0.5 - 1.5 mm. Torque Specification - Crankshaft Position Sensor: 9 - 11 N·m

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.