General Information
Lift And Support Points
In this manual: General Information
8steps
~48min
2/5difficulty
Done 0 of 8
Contents:
General Information
Lift Points And Precautions For Lift
Acquaint the following instructions below when using lift.- Keep the vehicle empty weight when lifting with lift. If it is inevitable, be careful not to exceeds the maximum weight of the lift.
- Use the counter weight or install the safety jack to prevent the vehicle from falling when removing heavy parts such as engine or transaxle.
- Install the rubber block to prevent the lift points from damage.
- Before operating the lift, make sure there is no tool, parts, equipment, or people under the vehicle.
- Follow the safety instructions in the manual provided by the lift manufacturer.
- Install jacks using only provided lift points in this manual. [Front]
[Rear]


- Place the vehicle on the lift to balance the front, rear, left and right sides of the vehicle slowly so that the vehicle centered on the lift.
- For safety, lift the vehicle that it slightly falls off the ground, and then shake the vehicle to check the support condition.
- If safety checked, lift the vehicle.

- Place the vehicle on the lift to balance the front, rear, left and right sides of the vehicle slowly so that the vehicle centered on the lift.
- Use wheel chocks to prevent vehicle from moving accidentally.

- Be careful not to let the lift interfere with underbody parts when lifting the vehicle.

- Use wheel chocks to prevent vehicle from moving accidentally.
- Do not install the floor jack except for the front subframe, rear crossmember, and lift points.
Was this page helpful?