Contents:
Single-Use Parts
Single-Use Parts Non-reusable parts (Single-Use Parts) Workshop manual provides “Components and Components Location” which can be used to identify “Non-reusable parts”. When repairing a vehicle, Non-reusable parts such as fasteners, gaskets, washers, clips and garnishes must be replaced. Kia Non-reusable parts are designed to be installed only once. Before working on a vehicle, check “Components and Components Location” to find the non-reusable parts in a system. ※ Symbol of Non-reusable parts
Symbol
Meaning
Do not reuse the part. Replace with a new one.
※ Example of “Components and Components Location”
Special Service Tools
Special Service Tool
Tool Name / Number
Illustration
Description
Outside Rear View Mirror Glass Remover Tool 0K876 - L2100
Used when removing outside rear view mirror glass
Outside View Mirror Assembly Fixing Stand 0K876 - C5100
Used when fixing the outside rear view mirror assembly
Troubleshooting
Troubleshooting
Wind Noise Around The Door
Suspected Causes
Correction
Gap on weatherstrip
Replace weatherstrip
Water Leaks on The Sunroof
Suspected Causes
Correction
Incorrect installation and deformation of sunroof frame weather strip
Replace
Seal damaged
Apply sealant
Sunroof Wind Noise
Suspected Causes
Correction
Deformation and separation of the deflector
Replace and reinstall
Sunroof Operating Noise (Noise When Opening or Closing)
Suspected Causes
Correction
Foreign matter on the guide rail
Cleaning the rail and apply the grease
Excessive wear and breakage or tilt lever shoe
Replace tilt lever shoe
Sunroof Malfunction (Motor Works, Sunroof Moves Partially or Does Not Move)
Suspected Causes
Correction
Foreign matter on the guide rail
1. Cleaning the rail and apply the grease
2. Adjustment or replacement
Faulty engagement drive cable and motor pinion.
Adjustment or replacement
Sunroof operating resistance or interference (with cable, weather strip) increased.
Adjustment or replacement
Motor initial value (position value) loss
Motor Initialization
Sunroof Motor Noise
Suspected Causes
Correction
Faulty engagement drive cable and motor pinion.
Adjustment or replacement
Motor pinion gear worn out or broken
Motor Replacement
Drive cable worn out or breakage
Replace
Door glass impossible to operate
Suspected causes
Correction
Incorrect installation of the window glass
Adjust position
Motor fault or regulator breakage / deformation
Modification or replacement
Door Does Not Open or Close Completely
Suspected causes
Correction
Incorrect installation of door or striker, latch sorting fault
Adjust position
Breakage of the door handle and latch, deformation, incorrect installation, deformation of checker
Modification or replacement
Not enough grease on door hinge and checker
Apply grease
Hood does not completely close or open
Suspected Causes
Correction
Incorrect on location of the striker and latch
Adjustment
Incorrect hood installation
Adjustment
Hood bumpers height unconformity
Adjustment
Leaks in Windshield or Tailgate Glass
Suspected Causes
Correction
Seal damaged
Apply sealant
Flange damaged
Modification
Wiper Blade Wiping / Vibration / Noise
Suspected Causes
Correction
When glass surface contaminated
Removing the foreign matters and water-repellent coating by using a wet towel.
When wiper blade is contaminated
Clean the rubber using a clean wet towel
Angle of wiper arm
Adjust the angle of wiper arm after checking vehicle types
Rubber abrasion
In case of the rubber abrasion, replace with a new one.
Blade faulty
When the wiper is faulty, inspect for "ticking" sound
Clearance
Press the left and right sides of the blade by using a tool
In this section
Was this page helpful? 👍 Yes 👎 No