Smart Cruise Control (Stop & Go) (SCC) ECU
Description and Operation
Description
The Smart Cruise Control unit is installed at the front right side of the chassis. The radar sensor is built into the front of the unit. This sensor detects vehicles and objects ahead of the vehicle. The radar sensor can detect up to 64 objects ahead of the vehicle. A warning is triggered when the vehicle deviates from the reference points of horizontal and vertical alignment during operation. This sensor communicates with the instrument cluster, warning buzzer, smart cruise control switch, Electronic Stability Program (ESP), ECM and TCM via the CAN bus. The sensor monitors vehicle speed through CAN communication between the ESP system and the ECM and TCM.
Circuit Diagrams
Schematic Diagrams

Terminal Function

| Pin No. | Terminal Function |
| 1 | IGN |
| 2 | - |
| 3 | - |
| 4 | L-CAN HIGH |
| 5 | L-CAN LOW |
| 6 | - |
| 7 | - |
| 8 | C-CAN HIGH |
| 9 | C-CAN LOW |
| 10 | GROUND |
Repair Procedures
Removal
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
Remove the front bumper assembly.
(Refer to Body - "Front Bumper Assembly")
Disconnect the front radar connector (A).

Loosen the nuts (A) and bolt (B), then remove the front radar (C).
Tightening torque: (A, B): 9.8–11.8 N·m

Installation
Install in the reverse order of removal.
Perform SCC variant coding.



Perform radar alignment of the Smart Cruise Control (Stop & Go) control unit.
(Refer to Engine Electrical System – "Smart Cruise Control (Stop & Go) Unit-Radar")
Test yourself
A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.