Kia Stonic Quiz
Steering

MDPS ECU

In this manual: Steering
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
14steps
~84min
3/5difficulty
Done 0 of 14

Repair Procedures

Removal

  1. Battery

  2. Untere Armaturenbrettverkleidung abbauen.

    (Siehe Karosserie - "Untere Armaturenbrettverkleidung")

  3. MDPS EUC-Steckverbinder abziehen.

  4. MDPS-ECU-Schrauben lösen, dann das MDPS ECU ausbauen.

  5. Perform "Steering Angle Sensor (SAS) Calibration" and "Steering Feel Torque Zero Point Adjustment".

  6. Turn the ignition off, then wait at least 10 seconds. Start the engine and check the operation.

Diagnosis using KDS

Steering Angle Sensor (SAS) Calibration and Steering Feel Torque Zero Point Adjustment

  1. Connect the self-diagnosis connector (16-pin) on the driver's side lower dashboard to the diagnostic tester, then turn the ignition on and turn on the diagnostic tester.

  2. Select "Vehicle Model" and "Motor Driven Power Steering" on the KDS selection screen.

  3. Select "Steering Angle Sensor (SAS) Calibration" on the KDS screen, then select OK.

  4. Bei der Durchführung des Tests die Bildschirmanweisungen befolgen.

  5. Select "Steering Feel Torque Zero Point Adjustment" on the KDS screen and select OK.

  6. Bei der Durchführung des Tests die Bildschirmanweisungen befolgen.

  7. Den Fehlercode löschen.

  8. Turn the ignition on, then wait at least 10 seconds before starting the engine. Then make sure the MDPS operates correctly.

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.