Kia Picanto JA Quiz
Engine Control System/Fuel System

Pipe Delivery

In this manual: Engine Control System/Fuel System
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
9steps
~64min
4/5difficulty
2special tools
0102030405032.424N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Repair Procedures

Removal

  1. Relieve the residual fuel pressure in the fuel line. (Refer to Fuel System – "Relieve Residual Fuel Pressure in Fuel Line")
  2. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  3. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold")
  4. Remove the injector and delivery pipe bracket (A).
  5. Remove the flanged nut (A) from the high-pressure fuel pump using the special service tool [SST No.: 09314-3Q100 or 09314-27130]. High-pressure fuel pipe flange nut: 26.5–32 N·m
  6. Remove the mounting bolts (A) and then separate the low-pressure fuel line.
  7. Remove the mounting bolts (B) and remove the high-pressure fuel line (C).
  8. Remove the mounting bolts (A) and remove the delivery pipe and injector assembly (B) from the engine.
  9. Disconnect the injector and the pressure sensor connector on the delivery pipe (A).

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.