Engine

Air Cleaner and Air Duct

~1min read
Exploded View
1. Air duct hose and resonator assembly 2. Front air duct 3. Grommet
4. Air cleaner case (lower) 5. Grommets 6. Air cleaner case mounting bracket
7. Bracket 8. Air cleaner filter 9. Air cleaner case (upper)
10. Mass air flow sensor A. Air cleaner case side clips B. To electric throttle control actuator. Refer to Exploded View.
Front
Removal and Installation

REMOVAL

Remove front air duct.

Remove brake fluid level sensor harness connector from brake fluid level sensor.

Remove sub tank bracket from cowl top extension.

Disconnect the tube clamp at the electric throttle control actuator and at the air duct hose and resonator assembly.

Disconnect the blow-by hose. Refer to Exploded View.

Remove air duct hose and resonator assembly.

Disconnect the harness connector from mass air flow sensor.

Remove mass air flow sensor from air cleaner case (upper) (if necessary).

  • Do not shock it.

  • Do not disassemble it.

  • Do not touch its sensor.

Disconnect the transaxle air breather hose. Refer to Removal and Installation.

Remove bolts and pull air cleaner case (lower) upward to remove from the grommets.

Remove air cleaner assembly.

INSPECTION AFTER REMOVAL

Inspect air cleaner case (upper), air cleaner case (lower), front air duct, air duct and resonator assembly for cracks or tears. Replace as necessary.

INSTALLATION

Installation is in the reverse order of removal.