Rocker Cover

| 1. | Camshaft position sensor (Bank 2) | 2. | O-rings | 3. | Camshaft position sensor (Bank 1) |
| 4. | O-rings | 5. | Rocker cover (Bank 1) | 6. | Rocker cover gasket (Bank 1) |
| 7. | Rocker cover gasket (Bank 2) | 8. | Rocker cover (Bank 2) | A. | Refer to Removal and Installation (bank 1) or Removal and Installation (bank 2). |
| Engine front |
REMOVAL
Remove the engine room cover. Refer to Removal and Installation.
Disconnect the harness connector from air fuel ratio sensor 1 (bank 2).
Remove blow by hose from rocker cover.
Remove camshaft position sensors.

Unclip the camshaft position sensor harness retainers.
Remove the ignition coils. Refer to Removal and Installation (bank 2).
Remove rocker cover bolts from cylinder head in the reverse order shown.

| : Engine front |
Remove the rocker cover and gasket.
Remove the oil filler cap from the rocker cover (if necessary).
INSTALLATION
Installation is in the reverse order of removal.
Blow by hose clamps should be installed facing upwards.
Install press fit hoses so that the white mark faces the rib of the connector.
Apply sealant to the areas on the front corners using suitable tool.

Use Genuine Silicone RTV Sealant or equivalent. Refer to Recommended Chemical Products and Sealants.
Tighten the rocker cover bolts to specification in two steps in order shown.


: Engine front Rocker cover bolts Step 1 : 2 N·m Step 2 : 8,3 N·m
REMOVAL
Remove the engine room cover. Refer to Removal and Installation.
Disconnect the harness connector from air fuel ratio sensor 1 (bank 1).
Remove the front air duct and air duct hose and resonator assembly. Refer to Removal and Installation.
Remove the intake manifold collector. Refer to Removal and Installation.
Remove camshaft position sensors.

Disconnect the PCV hose from the rocker cover.
Disconnect the ignition coil harness connectors.
Remove ignition coils. Refer to Removal and Installation (bank 1).
Remove rocker cover bolts from cylinder head in the reverse order shown.

| : Engine front |
Remove the rocker cover and gasket.
INSTALLATION
Installation is in the reverse order of removal.
Blow by hose clamps should be installed facing upwards.
Install press fit hoses so that the white mark faces the rib of the connector.
Apply sealant to the areas on the front corners using suitable tool.

Use Genuine Silicone RTV Sealant or equivalent. Refer to Recommended Chemical Products and Sealants.
Tighten the rocker cover bolts in two steps in order as shown.


: Engine front Rocker cover bolts Step 1 : 2 N·m Step 2 : 8,3 N·m