Engine

Intake Manifold

~1min read
0102030405010.88N·mlb·ft
Tightening torque found on this page
Exploded View
1. Intake manifold 2. Intake manifold gasket A. Refer to Removal and Installation.
Removal and Installation

REMOVAL

Remove fuel injectors and fuel tube. Refer to Removal and Installation.

Remove the intake manifold and the intake manifold gaskets. Loosen nuts and bolts in reverse order as shown.

INSPECTION AFTER REMOVAL

Surface Distortion

  • Using straightedge (A) and feeler gauge (B), inspect the surface distortion of the intake manifold.

    Standard : 0.1 mm (0.004 in)

INSTALLATION

Installation is in the reverse order of removal.

  • Install intake manifold studs (if removed) and tighten to specification.

    Intake manifold studs : 10,8 N·m
  • Install intake manifold nuts and bolts in two steps in the numerical order as shown.

    Step 1 : 7,4 N·m
    Step 2 : 26 N·m

INSPECTION AFTER INSTALLATION

Make sure there are no fuel leaks at the connections as follows:

Apply fuel pressure to fuel lines by turning ignition switch ON (with engine stopped). Then check for fuel leaks at connections.

Start the engine and rev it up and check for fuel leaks at connections.