Steering Column

ECU Terminals

~3min read

ECU TERMINALS

TERMINAL INSPECTION

*a

Component without wire harness connected

(Steering lock ECU (steering lock actuator or upper support assy))

-

-

(a) Measure the voltage and resistance according to the value(s) shown in the table below.

Terminal No. (Symbol)

Input/Output

Wire Color

Terminal Description

Condition

Specified Condition

Related Data List Item

F78-1 (GND) - Body ground

-

W-B - Body ground

Ground*1

Always

Below 1 Ω

-

F78-3 (IGEI) - F78-1 (GND)

Input

P - W-B

Steering lock motor drive control signal (motor drive control signal transmitted by the certification ECU (smart key ECU assy))

A door is opened when the conditions below are met, and the steering lock motor is activated:

  • Shift lever in P position
  • Steering lock unlocked in advance with the key on hand and the engine switch in ON (IG)
  • After the conditions described above are met, the engine switch is turned to OFF

Pulse generation (see waveform)

Smart key
  • Power Supply Short
  • Unlock Request Receive
  • Lock Request Receive

F78-4 (SLP1) - F78-1 (GND)

Output

G - W-B

Steering lock bar position signal (output signal from the steering unlock sensor)

Steering locked → unlocked

11 to 14 V → Below 1.5 V

Smart key
  • Sensor Value

F78-5 (LIN) - F78-1 (GND)

Input/Output

V - W-B

LIN communication line

-

-

Smart key
  • Steering Lock Start Cond

F78-6 (IG2) - F78-1 (GND)

Input

B - W-B

Power supply mode signal (IG2 power input for steering lock actuator assy or upper support assy)*1

Engine switch OFF → Engine switch ON (IG)

Below 1 V → 11 to 14 V

-

F78-7 (B) - Body ground

Input

L - Body ground

Power supply source*1

Always

11 à 14 V

-

  • *1: If there is a problem with the power supply source input, the certification ECU (smart key ECU assy) may store DTC B2786.

NOTICE:

1 motor and 2 sensors are built into the steering lock actuator assy or upper support assy.

HINT:

  • When measuring with the lock motor stopped, no operation is necessary.
  • To take measurements while the lock motor is operating, perform one of the following operations:
    • To unlock the steering, carry the key and set the engine switch to ON (ACC) or ON (IG).
    • To lock the steering, set the engine switch to OFF with the shift lever in P, then open one of the doors.

(1) Waveform

*a

Steering lock motor does not operate

*b

Steering lock motor operates

Item

Content

Tester Connection

F78-3 (IGEI) - F78-1 (GND)

Oscilloscope Setting

2 V/DIV., 200 ms/DIV.

Vehicle Operating Conditions

Steering lock motor not operating → operating → not operating