Steering Column

Diagnostic System

~2min read

DIAGNOSTIC SYSTEM

DESCRIPTION

(a) The steering lock ECU (steering lock actuator assy or upper support assy) stores DTCs when a malfunction occurs in the system. These DTCs can be checked using the Techstream.

NOTICE:

  • When the Techstream is used with the engine switch in the OFF position to check DTCs or Data List information related to the smart key system, the Techstream may not operate until one of the following actions is performed: 1) Switch a welcome light switch from ON to OFF at intervals of no more than 1.5 seconds until communication between the Techstream and the vehicle is established, or 2) connect the Techstream to the vehicle, select the vehicle type in manual mode, then select the following menus: Body Electrical / Smart Key.
  • Do not remove any fuse or disconnect the negative (-) battery terminal cable before checking and recording DTCs, as this will erase the data stored in the ECUs.
  • DTCs may have been recorded due to problems not related to the steering lock system. Be sure to check and record all DTCs output for other systems.

(b) The steering lock ECU (steering lock actuator set or upper support) is not connected to the CAN communication system. Therefore, communication with the Techstream is performed via the certification ECU (smart key ECU assembly).

(c) The steering lock ECU (steering lock actuator set or upper support) only records DTCs output for current malfunctions. Previous DTCs are not recorded.