Precautions
PRECAUTION
PRECAUTIONS WHEN CHECKING DTCs
(a) When the cable is disconnected from the negative (-) battery terminal, the DTCs stored in the memory of the steering lock ECU (steering lock actuator assembly or upper support) are erased. Be sure to record the output DTCs immediately.
(b) Normally, when the engine switch is OFF, even if the Techstream is connected to the vehicle, the information stored in the ECUs related to the smart key system (certification ECU [smart key ECU assembly], power source control ECU, main body ECU, etc.) cannot be read. However, the smart key system DTCs and Data List information can be checked, even when the engine switch is OFF, using either of the following two methods:
- Connect the Techstream to the vehicle, then switch a welcome light switch from ON to OFF at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle is established (the Techstream screen changes when communication is established).
- Connect the Techstream to the vehicle and select the vehicle type in manual mode, then select the following menus: Body Electrical / Smart Key.
PRECAUTIONS WHEN REPLACING THE STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY OR UPPER SUPPORT)
(a) If the steering lock ECU (steering lock actuator assembly or upper support) is replaced, be sure to confirm that the steering lock is released by turning the steering wheel to the right and left before starting the engine. If the steering is locked for any reason, open and close a door with the engine switch OFF, then release the steering lock by pressing the engine switch. This prevents the engine from starting while the steering is locked.
REGISTRATION PRECAUTIONS
(a) When replacing any of the following parts, refer to the registration procedure.
Click here![]()
(1) Certification ECU (smart key ECU assembly)
(2) ECM
(3) Steering lock ECU (steering lock actuator or upper bracket assembly)
(4) Key (electronic key transmitter sub-assembly)
(5) ID code box (immobiliser code ECU)
(6) Main body ECU (multiplex network body ECU)
STEERING LOCK / UNLOCK FUNCTION PRECAUTIONS
(a) After the engine switch is turned to OFF and any door is opened and closed, the steering wheel is locked due to the steering lock function. Turning the engine switch on again automatically cancels the steering lock function.
(b) To prevent the steering lock motor from overheating, its operation may be suspended if the steering is locked and unlocked repeatedly within a short period. In this case, do not operate the engine switch. After approximately 10 seconds, the steering lock motor will operate normally again.