System Description
SYSTEM DESCRIPTION
STEERING LOCK RELEASE CONDITIONS
(a) When the following condition is met, the unlock operation is performed.
- The engine switch is in ON (ACC) or ON (IG) position.
HINT:
When the engine switch is turned to ON (ACC) or ON (IG) and the key and the certification ECU (smart key ECU assembly) are verified, the steering is unlocked.
(b) When any of the following conditions is met, a key verification is performed.
- The engine switch is pushed.
- The brake pedal is depressed so that the engine can be started.
- 30 seconds have elapsed after a door was opened or closed.
HINT:
- A key verification is performed when the code transmitted by the key and the code calculated by the certification ECU (smart key ECU assembly) are compared to confirm that they match.
- The certification ECU (smart key ECU assembly) verification is performed when the S code and L code are verified at engine start or when the engine switch is pushed. The ID code box (immobiliser code ECU) uses the S code to determine whether the certification ECU (smart key ECU assembly) is authorised. The steering lock ECU (steering lock actuator or upper bracket assembly) uses the L code to determine whether the ID code box (immobiliser code ECU) is authorised.
STEERING LOCK ENGAGEMENT CONDITIONS
(a) When all of the following conditions are met and the certification ECU (smart key ECU assembly) has been verified, the lock operation is performed.
- The engine switch is in OFF position.
- The shift lever is in P position.
- A door is opened or a door lock operation (door lock, remote door lock, or key-linked lock operation*) is performed.
HINT:
*: This is the lock/unlock operation using the mechanical key.
WARNING FUNCTION
(a) A smart key system check message is displayed on the multi-information display of the combination meter assembly when any of the following occurs: 1) a malfunction in the vehicle speed signal is detected, 2) a malfunction that may interfere with the operation of the steering lock ECU (steering lock actuator or upper bracket assembly) is detected.
If a malfunction occurs that causes the message to be displayed, the engine cannot be started once the engine switch has been turned to OFF.
HINT:
DTCs are stored in all of the cases listed above.
STEERING LOCK ECU DESCRIPTION (STEERING LOCK ACTUATOR ASSY OR UPPER SUPPORT ASSY)
(a) The steering lock ECU and steering lock motor are integrated into the steering lock actuator assy or upper support assy of the steering column assy.
(b) The steering lock ECU (steering lock actuator assy or upper support assy) is not connected to the CAN communication system. However, the steering lock ECU (steering lock actuator assy or upper support assy) is connected to the certification ECU (smart key ECU assy) via LIN communication, and communicates with other components via the CAN communication system through the certification ECU (smart key ECU assy).