Chassis
CHASSIS
INSPECT STEERING GEAR BOX AND LINKAGE
(a) Check the steering wheel play.
Click here![]()
(b) Make sure the steering linkage has no play and is not damaged.
(1) Make sure the tie rod ends have no play.
(2) Make sure the joints and dust boots are not damaged.
(3) Make sure the boot clamps are not loose.
(4) Make sure the steering gear box is not damaged.
INSPECT BALL JOINTS AND DUST COVERS
(a) Make sure the ball joints do not have excessive play.
(1) Raise the front of the vehicle using a jack and place wooden blocks 180 to 200 mm (7.09 to 7.87 in.) high under the front wheels.
(2) Lower the vehicle until the front coil spring supports half of the normal load. Place safety stands under the vehicle for added safety.
(3) Make sure the front wheels are aligned straight ahead. Use wheel chocks on all 4 wheels.
(4) Using a pry bar, lift the end of the lower arm. Check the play.
Maximum vertical play of ball joint:
0 mm (0 in.)
(b) Check whether the dust cover is damaged.
INSPECT AXLE SHAFT BOOTS
(a) Make sure the axle shaft boot clamps are not loose and show no cracks, grease leaks, creases or deterioration.
INSPECT CONTINUOUSLY VARIABLE TRANSAXLE
(a) Visually check the transaxle for any signs of fluid leakage. If fluid is leaking, find the cause and repair it.
INSPECT FRONT AND REAR SUSPENSION
(a) Inspect the front and rear suspension.
for front suspension:
Click here
![]()
for rear suspension:
Click here
![]()