Removal

1. REMOVE FRONT WHEEL

Torque: 131 N·m

2. REMOVE FRONT FENDER APRON

3. DISCONNECT ABS SPEED SENSOR WIRE HARNESS

Remove the 2 bolts and disconnect the ABS speed sensor wire harness.

Torque: 13 N·m

4. DISCONNECT STEERING KNUCKLE FROM UPPER SUSPENSION ARM

(a) Support the lower suspension arm with a jack.

(b) Remove the cotter pin and nut.

Torque: 110 N·m

HINT: At the time of installation, if the holes for the cotter pin are not aligned, tighten the nut further up to 60.

(c) Using SST, disconnect the steering knuckle from the upper suspension arm.

SST 09628-6201 1

5. REMOVE UPPER SUSPENSION ARM

(a) Place matchmarks on the front and rear No. 2 adjust cams and body.

(b) Remove the 2 nuts, No. 1 and No. 2 camber adjust cams and upper suspension arm.

Torque: 98 N·m

HINT: At the time of installation, after stabilizing the suspension, torque the nuts.