DESCRIPTION
The main body ECU (multiplex network body ECU) receives headlight dimmer switch assembly (front fog light switch) information signals and illuminates the front fog lights.
WIRING DIAGRAM
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
PERFORM ACTIVE TEST USING TECHSTREAM
(a) Using the Techstream, perform the Active Test.
Click here  Main Body
Tester Display | Test Part | Control Range | Diagnostic Note |
Front Fog Light Relay |
Front fog light relay (FOG FR) |
OFF or ON |
- |
OK:
Front fog light relay (FOG FR) operates (front fog lights turn on).
| OK |
 |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
 |
|
INSPECT FRONT FOG LIGHT RELAY (FOG FR)
(a) Remove the front fog light relay (FOG FR) from the engine room relay block and junction block.
(b) Inscpect the front fog light relay (FOG FR).
Click here 
| NG |
 |
REPLACE FRONT FOG LIGHT RELAY (FOG FR) |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (FRONT FOG LIGHT CIRCUIT)
(a) Remove the front fog light relay (FOG FR) from the engine room relay block and junction block.
(b) Disconnect the 3H driver side junction block assembly connector.
(c) Disconnect the A30 fog light assembly LH connector.
(d) Disconnect the A31 fog light assembly RH connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
Front fog light relay (FOG FR) terminal 1 - Body ground |
Light control switch tail position |
11 to 14 V |
Front fog light relay (FOG FR) terminal 3 - Body ground |
Always |
11 to 14 V |
(f) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
Front fog light relay (FOG FR) terminal 2 - 3H-25 |
Always |
Below 1 Ω |
Front fog light relay (FOG FR) terminal 5 - A30-2 |
Always |
Below 1 Ω |
Front fog light relay (FOG FR) terminal 2 or 3H-25 - Body ground |
Always |
10 kΩ or higher |
Front fog light relay (FOG FR) terminal 5 or A30-2 - Body ground |
Always |
10 kΩ or higher |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY
(a) Remove the driver side junction block assembly.
Click here  |
 |
*a |
Component without harness connected
(Driver Side Junction Block Assembly) |
|
|
(b) Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click here 
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
3H-25 - A-7 (FFGO) |
Always |
Below 1 Ω |
| OK |
 |
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG |
 |
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY |
|