DESCRIPTION
The combination meter assembly receives the turn signal switch information and controls the turn signal lights.
WIRING DIAGRAM
NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
PROCEDURE
READ VALUE USING TECHSTREAM
(a) Using the Techstream, read the Data List.
Click here  Combination Meter
Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
Turn Signal Switch (Right) |
Turn signal switch (right) signal / OFF or ON |
OFF: Turn signal switch (right) off
ON: Turn signal switch (right) on |
- |
Turn Signal Switch (Left) |
Turn signal switch (left) signal / OFF or ON |
OFF: Turn signal switch (left) off
ON: Turn signal switch (left) on |
- |
Turn Switch Signal (Full Turn) |
Turn signal switch signal / OFF or ON |
OFF: Turn signal switch off
OFF: Turn signal switch on (Full Turn) |
Displays for both right and left turns. |
OK:
Normal condition listed above are displayed.
| OK |
 |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
 |
|
INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
(a) Remove the headlight dimmer switch assembly.
Click here 
(b) Inspect the headlight dimmer switch assembly.
Click here 
| NG |
 |
REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)
(a) Disconnect the J10 headlight dimmer switch assembly connector.
(b) Disconnect the J28 combination meter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
J10-14 (CR) - J28-28 (SW) |
Always |
Below 1 Ω |
J10-13 (TR) - J28-17 (ER) |
Always |
Below 1 Ω |
J10-15 (TL) - J28-16 (EL) |
Always |
Below 1 Ω |
J10-12 (EL) - Body ground |
Always |
Below 1 Ω |
J10-14 (CR) or J28-28 (SW) - Body ground |
Always |
10 kΩ or higher |
J10-13 (TR) or J28-17 (ER) - Body ground |
Always |
10 kΩ or higher |
J10-15 (TL) or J28-16 (EL) - Body ground |
Always |
10 kΩ or higher |
| OK |
 |
REPLACE COMBINATION METER ASSEMBLY |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|