When the battery saving control operates, the main body ECU (multiplex network body ECU) controls the operation of the DOME CUT relay that is built into the driver side junction block assembly to turn off the interior lights.
WIRING DIAGRAM
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
PERFORM ACTIVE TEST USING TECHSTREAM
(a) Perform the Active Test according to the display on the Techstream.
Click here
Main Body
Tester Display
Test Part
Control Range
Diagnostic Note
Relay for Interior Light Auto Cut Function
DOME relay
OFF or ON
ON: DOME CUT relay off (interior lights turn off)
OFF: DOME CUT relay on (interior lights turn on)
OK:
All of the interior lights turn off when ON is selected.
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
NG
CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - BATTERY)
(a) Disconnect the driver side junction block assembly connector.
*a
Front view of wire harness connector
(to Driver Side Junction Block Assembly)
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
3G-1 - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY
(a) Remove the driver side junction block assembly.
Click here
*a
Component without harness connected
(Driver Side Junction Block Assembly)
-
-
(b) Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click here
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
3I-19 - Battery negative (-) terminal
Battery positive (+) → 3G-1
Battery negative (-) → A-23 (DOMR)
11 to 14 V
Battery not connected to 3G-1 and A-23 (DOMR)
Below 1 V
OK
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)