Vehicle Interior
Taillight Circuit
DESCRIPTION
The main body ECU (multiplex network body ECU) receives headlight dimmer switch information signals and illuminates the taillights, license plate lights and front side marker lights.
WIRING DIAGRAM
NOTICE:
Inspect the bulbs and fuses for circuits related to this system before performing the following procedure.
PROCEDURE
PERFORM ACTIVE TEST USING TECHSTREAM
(a) Using the Techstream, perform the Active Test.
Click here
Main Body
Tester Display
Test Part
Control Range
Diagnostic Note
Taillight Relay
Taillight relay (TAIL)
OFF or ON
-
OK:
Taillight relay (TAIL) operates (taillights turn on).
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
NG
CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - BATTERY)
(a) Disconnect the driver side junction block assembly connector.
*a
Front view of wire harness connector
(to Driver Side Junction Block Assembly)
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
3G-1 - Body ground
Always
11 to 14 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY
(a) Remove the driver side junction block assembly.
Click here
*a
Component without harness connected
(Driver Side Junction Block Assembly)
-
-
(b) Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click here
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
3H-32 - Battery negative (-) terminal
Battery voltage applied between terminals 3G-1 and A-14 (TRLY)
11 to 14 V
Battery voltage not applied between terminals 3G-1 and A-14 (TRLY)
Below 1 V
OK
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
NG
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY
Was this page helpful? 👍 Yes 👎 No