Vehicle Interior
Parking Brake Switch Circuit
DESCRIPTION
The main body ECU (multiplex network body ECU) detects the condition of the parking brake switch assembly.
WIRING DIAGRAM
PROCEDURE
READ VALUE USING TECHSTREAM
(a) Using the Techstream, read the Data List.
Click here  Main Body
Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
Parking Brake SW |
Parking brake switch assembly signal / OFF or ON |
OFF: Parking brake switch off
ON: Parking brake switch on |
- |
OK:
Normal condition listed above are displayed.
| OK |
 |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
 |
|
INSPECT PARKING BRAKE SWITCH ASSEMBLY
(a) Remove the parking brake switch assembly.
Click here 
(b) Inspect the parking brake switch assembly.
Click here 
| NG |
 |
REPLACE PARKING BRAKE SWITCH ASSEMBLY |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
(a) Disconnect the 3H driver side junction block assembly connector.
(b) Disconnect the A5 parking brake switch assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
3H-18 - A5-1 |
Always |
Below 1 Ω |
3H-18 or A5-1 - Body ground |
Always |
10 kΩ or higher |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY
(a) Remove the driver side junction block assembly.
Click here  |
 |
*a |
Component without harness connected
(Driver Side Junction Block Assembly) |
|
|
(b) Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click here 
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
3H-18 - A-12 (PKB) |
Always |
Below 1 Ω |
| OK |
 |
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG |
 |
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY |
|
Was this page helpful?