DESCRIPTION
This circuit detects the ignition switch ON or off condition, and sends it to the main body ECU (multiplex network body ECU).
WIRING DIAGRAM
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
READ VALUE USING TECHSTREAM
(a) Read the Data List according to the display on the Techstream.
Click here  Main Body
Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
IG SW |
Ignition switch signal / OFF or ON |
OFF: Ignition switch off
ON: Ignition switch ON |
"OFF" is also displayed for this item when the ignition switch is ACC. |
OK:
Normal conditions listed above are displayed.
| OK |
 |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
 |
|
CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - BATTERY AND BODY GROUND)
(a) Disconnect the driver side junction block assembly connectors.
*a |
Front view of wire harness connector
(to Driver Side Junction Block Assembly) |
- |
- |
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
3G-1 - Body ground |
Always |
11 to 14 V |
3J-17 - Body ground |
Ignition switch ON |
11 to 14 V |
Ignition switch off |
Below 1 V |
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
3I-3 - Body ground |
Always |
Below 1 Ω |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY
(a) Remove the driver side junction block assembly.
Click here 
*a |
Component without harness connected
(Driver Side Junction Block Assembly) |
- |
- |
(b) Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click here 
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
A-32 (IG) - 3G-1 |
Battery not connected to 3J-17 and 3I-3 |
10 kΩ or higher |
Battery positive (+) → 3J-17
Battery negative (-) → 3I-3 |
Below 1 Ω |
| OK |
 |
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG |
 |
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY |
|