How To Proceed With Troubleshooting
|
HINT: Use these procedures to troubleshoot the audio and visual system. PROCEDURE
(a) Measure the battery voltage. Standard Voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace the battery.
(a) Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin. OK: Condensation is not likely being produced and the temperature is not high or extremely low. HINT:
(a) Check for DTCs and note any codes that are output. Click here (b) Clear the DTCs. (c) Recheck for DTCs by simulating the operation indicated by the DTCs.
(a) Refer to the Problem Symptoms Table. Click here
(a) Terminals of ECU Click here
HINT: After clearing DTCs, recheck for DTCs. Click here
|