Lighting (ext)

Diagnosis Circuit

~1min read
DESCRIPTION

The headlight leveling ECU assembly outputs DTC information to the Techstream via this circuit.

WIRING DIAGRAM
PROCEDURE
  1. CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU ASSEMBLY)

(a) Disconnect the A40 headlight leveling ECU assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A40-15 (PRST) - D1-7 (SIL)

Always

Below 1 Ω

A40-15 (PRST) - Body ground

Always

10 kΩ or higher


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE


NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.