Toyota Venza Quiz
Lighting (ext)

Lost Communication with ECM (U0101,U0073,U0126,U0129,U0142,U0182,U1000)

In this manual: Lighting (ext)
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
DESCRIPTION

The DTCs are stored when the CAN communication system is malfunctioning.

DTC No.

DTC Detection Condition

Trouble Area

U0101

Lost communication with ECM

CAN communication system

U0073

Control module communication bus off

CAN communication system

U0126

Lost communication with steering angle sensor

CAN communication system

U0129

Lost communication with skid control ECU

CAN communication system

U0142

Lost communication with main body ECU (driver side junction block assembly)

CAN communication system

U0182

Lost communication with AFS ECU (headlight swivel ECU assembly)

CAN communication system

U1000

Can communication failure (message registry)

CAN communication system
PROCEDURE

  1. CHECK FOR DTC

(a) Clear the DTCs (See page ).


(b) Check for DTCs (See page ).


OK:

DTCs are not output.


OK

USE SIMULATION METHOD TO CHECK

NG

GO TO CAN COMMUNICATION SYSTEM

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.