Four-door version

Rear side seat belts

Slowly pull out belt 24 and latch its tongue 26 into the red locking buckle 25.

Rear centre seat belt (depending on vehicle version)

Slowly pull out belt 27 from reel B.

Latch tongue 29 into the corresponding black buckle 28, if the vehicle is equipped with it.

Latch sliding guide 30 into red housing 31.

The following recommendations apply to both front and rear seat belts.

• No changes may be made to the original safety system components: this applies to the belts, seats and their mountings. In special cases (e.g. installing a child seat), contact an authorised brand partner.
• Do not use any additional items that could loosen the belts (e.g. clothes pegs, clips, etc.): in an accident, a loose seat belt may cause injury.
• Never place the shoulder part of the belt under the arm or behind the back.
• The belt may only be used to restrain one person per seat. Under no circumstances may the belt be fastened around a child seated on an adult's lap.
• The belt must not be twisted.
• After an accident, have the operation of the belts checked and replace them if necessary. Do the same with a belt that is not working correctly.
• When folding and unfolding the rear seat, make sure the seat belts are correctly positioned so that they can perform their function properly.
• Take care to insert the buckle into the correct buckle receptacle.
• Do not place objects in the area of the belt buckle, as this may prevent it from working properly.
• Check that the buckle is correctly positioned (it must not be hidden, pinched, or pressed by any person or object).