Keyless Entry Settings
Turning Keyless Entry On and Off
- Turn the ignition on with the original key that was not created as My Key.
- Press Settings on the touchscreen.
- Press Vehicle Settings .
- Press Locks.
Reprogramming the Unlock Function
You can turn on the two-stage unlock function, which unlocks only the driver door when the unlock sensor is touched.
Press and hold both the lock and unlock buttons on the remote control for four seconds to turn the two-stage unlock on or off.
If you program the unlock function so that only the driver door unlocks, you can unlock all other doors from inside your vehicle using the power door lock control. You can unlock individual doors by pulling the interior door handles of those doors.
Creating Personal Access Codes
To create your personal access code:
- Enter the factory code.
- Press 1·2 on the keypad within five seconds.
- Enter your personal five-digit code.
- Press 1·2 on the keypad to save personal code one.
The doors lock and then unlock to confirm that programming was successful.
To program additional personal access codes, repeat steps 1-3, then for step 4:
- Press 3·4 to save personal code two.
- Press 5·6 to save personal code three.
- Press 7·8 to save personal code four.
- Press 9·0 to save personal code five.
Tips:
- Do not set a code that uses the same five numbers.
- Do not use five numbers in sequential order.
- The factory code works even if you have set your personal code.
Erasing All Personal Access Codes
- Enter the factory-set five-digit code.
- Press and release 1·2 on the keypad within five seconds.
- Press and hold 1·2 for several seconds. This must be done within five seconds of completing step 2.
All personal codes are erased and only the factory-set five-digit code works.
Test yourself
A quick Ford Escape quiz: every answer comes with an explanation and a link to the manual page.