Heating,Ventilation And Air Conditioning
Auto Temperature Control Unit Removal and Installation
In this manual: Heating,Ventilation And Air Conditioning
4steps
~24min
2/5difficulty
Done 0 of 4
Contents:
Auto Temperature Control Unit Removal and Installation
Removal
|
- Turn the POWER OFF, separate the auxiliary battery (12 V) ( - ) terminal, and disconnect the high voltage service interlock connector.
- Open the front trunk (A).
- Open the auxiliary 12 V battery service cover (A).
- Turn the POWER OFF, separate the auxiliary battery (12 V) ( - ) terminal (A).
Tightening torque : 7.8 - 9,8 N·m
- Disconnect the service interlock connector (A).
- Wait more than 5 minutes for capacitor of the high voltage battery system to be discharged completely.
- When working on a vehicle during discharging the capacitor, it can cause an electrical shock or injury, so follow the manual.
The service interlock connector cannot be completely removed.
- Open the glove box (A).
- Remove the screws (A).
- Remove the auto temperature control unit (A) after disconnecting the connectors (B).
Installation
|
- Install in the reverse order of removal.
Heater and Air Conditioning Controller On Vehicle Inspection
On Vehicle Inspection
Diagnostic with KDS
- The heater and A/C controller can be more quickly diagnosed for problems with the KDS (Refer to "DTC guide").
- Self diagnosis : Inspect the Diagnostic Trouble Code (DTC) with the KDS. (Refer to DTC guide when fault code is found.)
Heater and Air Conditioning Controller Removal and Installation
Removal
|
- Remove the infotainment keyboard. (Refer to Body - "Infotainment Keyboard")
Installation
|
- Install in the reverse order of removal.
Was this page helpful?